This will help us understand if the problem is a drive problem or a system problem. In addition, if another drive is available, check this drive in the same system. My laptop is an ASUS Vivobook X512DA, I can access bios by pressing the F2. However, when I plug this SSD into my laptop, the latest don’t boot on my bootable USB stick and I’m not able to access its BIOS.

If the problem persists, then the cable was not the cause of the problem. So I recently bought a WD Blue SN550 500 GB which was meant to replace the mSATA M.2 from my laptop. If it still doesn't work try to replace it with another cable. SATA connections are pretty gentle and might sometimes fall out their connections.Ī good way to test a cable is re-plug it into the system and into the drive. In case of damaged SATA cables or connection the BIOS will not detect the drive.

SOLUTION - Problems in cables and connections: In the sample below you can see how it is possible to enable or disable every SATA port by putting it OFF or ON. When you add a drive to the system, it may be needed to enable the port by turning it ON in System Setup. Those are my last two options and if it's not detected I'll assume it. If your drive is NOT detected it may be because it is turned OFF in System Setup. Disabled SATA ports in BIOS, rebooted and re-enabled ports and re-booted (a wild shot in the dark on this one) I haven't thrown the SSD into another computer yet to see if it's detected or see if it's detected via USB. There are few reasons for not detecting a drive in the BIOS: However, if your SSD is not showing in BIOS, you should check the things. Usually, an SSD will be automatically detected in BIOS when you attach it. Windows cannot be installed to this disk. SOLUTION - Drive is not detected by the BIOS: SSD not recognized by Windows 11/10/8/7 Setup. In some cases the BIOS will display the drive model number while in other cases it will only indicate the existence of a drive and its capacity. Faulty SSD After verifying that your SATA port is set to Auto-Detect or is enabled, if you find that your SSD is not being detected (auto-detected) by the system BIOS, try the following steps to try and isolate/troubleshoot the problem. In most cases the SSD will be automatically detected by the BIOS. Serial ATA drivers are not properly installed. SOLUTION - Detecting the drive in the BIOS: Sometimes it's not one of the Function keys, but the Delete or ESC keys.įor the most up to date information about your BIOS, please look for information provided by the BIOS manufacturer or the SATA controller manufacturer. It usually requires the push of a function key, such as F1, F2 or F10, to get access to it. The BIOS can normally be accessed when you start your computer. The initial function of the BIOS is to identify, test, and initialize system devices such as the video display card, hard disk, USB devices and other hardware. The BIOS is system software embedded inside your computer that helps the computer to start up and to set most of its hardware peripherals.

Sandisk ssd not detected in bios